Hoover DYC 893B-80 Tumble dryer disconnected the wires on the control panel.
Customer Question
peter kennon asks:
My inquisitive grandson disconnected the wires on the control panel.I have managed to replace the connectors back into the correct sockets,but I am having difficulty replacing the small white connector with three white wires that seem to go on the side of the pcb module.There are two of these,one has a short lead which I have put next to the connector which has 7 wires on it.But I cannot fit the one with a longer lead as the pcb doesn`t have a cut out to accept this connector. a picture would be ideal of these fitted or is this cable not fitted and just for other models.Hope you understand this. Thanks in advance Peter.
Model: DYC 893B-80
Paul Says:
I will try and help with this problem Hoover DYC 893B-80 Tumble dryer
Hi, the picture is not clear but I can tell you there is a location lug inside the white holder with 3 wires, this stops it going onto the wrong connection point on the printed circuit board. The location lug when you compare it to the circuit board has a slot which this slides into. Please re-check all wiring connections that your grandson pulled off.
I've also included some very useful videos for you below on your Hoover tumble dryer this will assist you in the future if you ever have a problem.
Please see images below
Hoover DYC 893B-80 Tumble dryer
List of spare parts for Hoover DYC 893B-80 Tumble dryer
Parts for This Model
Showing compatible parts for model DYC 893B-80